Guide

Key fob not working? Battery, resync, reprogram or replace

A new coin battery fixes most fobs that stop working, and even with the battery completely dead, the fob will usually still get you into a push-to-start car and on your way. When it's more than the battery, the fix depends on the car.By Pacific Beach LocksmithUpdated November 8, 20265 min read

Start with the battery

A fob battery rarely dies all at once. Over a few weeks you find yourself standing closer to the car or pressing twice, or the dashboard warns of a low key battery or says no key is detected. A new battery is the first fix and often the only one.

  • Find the size. Most fobs take a flat coin cell, very often a CR2032, but it varies. The size is printed on the old battery and listed in the owner's manual.
  • Open the case gently. Most split along a seam with a notch for a coin or a small screwdriver. On many smart keys the notch is under the mechanical key, so slide that out first.
  • Note which side faces up before the old cell comes out, and fit a fresh, name-brand cell.

A battery change doesn't erase the programming on most fobs. A few older remotes need a quick resync afterward, and the manual describes how.

Dead fob, push-to-start car: getting in and getting going

A flat fob battery won't strand you, because the fob has two backups.

The hidden key

Almost every smart fob has a mechanical key inside, released by a small button or slide. The driver's door has a keyhole for it, though on many cars it's hidden under a small cap on the door handle that you lever off gently with the tip of the key. The alarm may sound until the car recognizes the fob.

Starting the engine

The fob also carries a chip the car can read at very short range, even with a dead battery. On many cars you hold the fob against the start button as you press it. Others have a marked spot or slot on the steering column, in the center console or in a cup holder. It differs by car, so check the owner's manual, usually in the section on a discharged key battery.

If you can't find the hidden key or it won't open the door, that's a car lockout, and the car is opened with non-destructive entry tools.

Buttons dead, but the key still starts the car

On cars with a turn key and a remote built into the head, the remote and the immobilizer chip are separate circuits. If the car starts but the lock and unlock buttons do nothing, even with a new battery, the remote has lost its programming or failed.

On some systems, a remote pressed many times out of the car's range, in a pocket or by a child, falls out of step with the car and needs a resync. Some vehicles, mostly older ones, let the owner do this with a sequence of key turns and button presses from the manual. Many newer ones need a programming tool, which makes it a job for a locksmith or the dealer.

A fob that went in the water

A fob that rides in a board-short pocket around Pacific Beach or Mission Beach gets wet sooner or later. If yours did:

  1. Take the battery out right away, before you test any buttons.
  2. Open the case. After salt water, gently clean the board with isopropyl alcohol on a cotton swab, because salt left behind keeps corroding it.
  3. Brush sand out of the buttons and the seam, let everything air dry for a day or two, then fit a fresh battery.

The chip that starts the car can survive even when the buttons don't, so try the backup start spot before writing the fob off. If the fob is still somewhere in the surf, read what happens when you lose your only car key.

Cracked cases, worn buttons and broken blades

Years of drops on concrete show up as a split case, a button worn through, a battery that rattles loose or a flip key snapped at the hinge. If the electronics still work, the board can sometimes move into a new case. Otherwise a replacement fob is programmed to the car and the damaged one is removed from the car's memory. A broken blade gets a newly cut one, and if part of it is still in the door or ignition, see the broken key guide first.

When it's the car, not the fob

Try the spare. If it works, the problem is the first fob. If neither works, even with fresh batteries, look at the car.

  • A weak or dead car battery. Dim or no dashboard lights, or a click when you try to start. The keyless receiver needs power too, so open the door with the hidden key and deal with the battery first.
  • An aftermarket alarm or remote start, which has its own receiver and its own faults.
  • A fault in the car's receiver or immobilizer. A key-not-detected message with two good fobs points here, and that diagnosis is often dealer work.

Who can do what: you, a locksmith, the dealer

  • You: the battery, the hidden key, the backup start spot, and any owner programming procedure in your manual.
  • A locksmith: program a new or replacement fob, add a spare, cut the mechanical key and erase a lost fob from the car, all where the car is parked. See car key and fob replacement.
  • The dealer: vehicles whose programming is restricted to dealer tools, and faults in the car itself.

Which cars a locksmith can program depends on the exact vehicle and changes as the tools are updated, so start with the year, make and model. You get a yes or no and a price on the phone (how quotes work). If you bought a fob online, send the part number first, because some can't be programmed. The car key questions cover common cases, and the automotive locksmith page lists everything done on site.

Questions people ask

Do I need to reprogram my fob after changing the battery?

Usually not. Most fobs keep their programming through a battery change. If the buttons still do nothing with a fresh battery fitted the right way up, check the owner's manual for a resync procedure, or give us a call.

Can I start a push-to-start car with a dead fob?

On most cars, yes. The chip in the fob can be read at very short range without battery power, so you hold the fob against the start button or put it in the backup spot shown in the manual. Use the hidden mechanical key to open the door first.

Can a locksmith program a key fob, or does it have to be the dealer?

For most vehicles a locksmith can program a fob at the car, without a tow. A few vehicles restrict programming to dealer tools. Give us the year, make and model and we'll tell you which group yours is in.

Rather talk it through?

Call or text and describe what's going on. If it needs a visit, you'll hear the price before we head out.

Call (858) 842-9337(858) 842-9337 Text us

Have your ID handy, plus something showing it's your home or car.