Rekey when someone with a key leaves
A key that leaves with a former employee is out of your control, however friendly the goodbye. You can't know whether it was copied or lent, or whether it's sitting on a ring in someone's car. Rekeying the locks makes every old key useless without replacing the hardware. Rekey when:
- Someone leaves and can't hand back every copy, or you aren't sure how many copies there were.
- A key is lost or stolen, especially on a ring with anything that names the business.
- You move into a space. Previous tenants, contractors and the landlord's maintenance crew may all still have keys.
A worn or corroded lock may be worth replacing instead, and the rekey or replace guide covers how to tell. If a lost key has you locked out at opening time, the business lockout call and the rekey can happen in one visit.
Key control: who has which key
Good key control means fewer rekeys, because you always know who has what.
- Keep a written list of every key: its number, who has it and the date they got it, signed when it goes out and again when it comes back.
- Have keys stamped with a number, so you know exactly which one is missing.
- Hand out fewer keys. The people who open and close need one. Keep the spare somewhere other than the register drawer.
- Collect keys on the last day, on the same checklist as the final paycheck.
A master key plan as the business grows
Add a back door, an office, a stockroom and a second shift, and the key ring gets heavy fast. A master key system gives each door its own key while one key above them opens everything: staff open the front and back, managers add the office, and you carry one key for all of it.
Plan it before you need it. A system laid out with room for doors you don't have yet grows without starting over, and when it's documented, a lost key means rekeying only the doors it opened. Interchangeable cores, which a control key swaps out in seconds after a key goes missing, are covered on our commercial locksmith page.
A front door that closes and latches every time
A front door that drifts shut and stops an inch short is an unlocked door, however good the lock. Test yours: open it all the way, let go and walk away. It should close at an even pace and latch without a push, and do the same from a few inches. Wind and heavy glass doors are both hard on closers, and storefronts near the beach on Garnet Ave and Mission Blvd get plenty of each.
- If it slams or crawls, the closer's sweep and latch speeds need adjusting.
- If it leaks oil, the closer has failed and needs replacing.
- If the key is hard to turn, the door may have sagged. On narrow aluminum storefront doors the deadbolt usually pivots out of the door edge into the frame, and once the door drops it stops lining up with its slot. Forcing the key can snap it or damage the cylinder.
Closers, latches and storefront locks are covered on our door closer and panic bar page.
The back door, the alley door and exit hardware
The back door is the one that gets propped open with a bucket for a delivery and forgotten. It's out of sight from the street, so it deserves at least as much hardware as the front.
- A commercial-grade lock installed straight, with a bolt that throws fully into a strike screwed into the frame.
- A latch guard if the door swings out: a steel plate that covers the gap at the latch.
- Security hinge pins or studs where the hinges are on the outside, so the door stays in its frame.
- A closer, and a rule that nobody props the door.
California's building and fire codes say an exit door must open from inside in one motion, with no key and no special knowledge or effort. The common exception is the main entrance, which may take a key on both sides, like a double-cylinder deadbolt, if the lock shows clearly when it's locked and a sign at the door reads THIS DOOR TO REMAIN UNLOCKED WHEN THIS SPACE IS OCCUPIED. Other exits don't qualify. The city's building and fire officials have the final word, so ask before changing an exit door, and never add a chain or padlock. We fit exit devices and commercial locks on that basis and won't install anything that traps people inside.
What to check at opening and closing
Opening
- Look at every exterior door for pry marks, a bent frame or a strike that has moved.
- Notice how the key turns. If it has started to stick, the guide to a stiff or stuck key explains why, and what not to spray in it.
Closing
- Every exterior door shut, latched and locked, checked by pulling on it rather than looking at it.
- Exit bars undogged. A bar dogged for business hours holds its latch retracted and leaves the door unlatched all night.
- Count the shared keys back onto their hook.
Near the water, salt air seizes the locks nobody uses, like the one on the alley door. The coastal hardware guide covers what holds up.
The morning after a break-in
- Don't go in if anyone might still be inside. Call 911 from outside. Otherwise call the police and get a report number.
- Photograph before you touch anything: the door edge, the frame, the lock, pry marks and anything missing.
- List every key that was inside the register, desk or office, and treat each one as lost.
- Secure the door the same day: a new strike, a reinforced frame, a replacement lock if it was damaged, and a rekey of every lock the missing keys fit.
That last step is what our break-in repair covers. For the insurance claim, keep your photos, the report number and an itemized invoice that lists what was damaged and replaced.
Questions people ask
How often should a small business rekey?
Whenever someone leaves with a key you can't account for, whenever a key is lost, and whenever you move into a space. There's no calendar rule. The trigger is a key you no longer control.
Is a "Do Not Duplicate" stamp enough to stop copies?
No. It's a request, and some key cutters honor it while others ignore it. If unauthorized copies worry you, a restricted keyway, with key blanks that aren't sold to hardware stores, is what actually controls duplication.
Can you work on our doors before we open?
Yes, within our hours of 7 am to 9:30 pm, every day. Commercial work can be booked early in the morning or after close, out of the way of customers. Every job is quoted before it starts, and the pricing questions explain how.